Owner guide · Peoria Toyota · Peoria, IL
Toyota 4Runner Headlight Bulb Guide
What the 4Runner uses for headlights, the one bulb you can replace yourself, its bulb number and wattage, how to change it and how to set the headlight leveling dial, from Toyota's 4Runner and 4Runner hybrid owner's manuals published in May 2026 (OM35C28U and OM35C29U), read November 16, 2026. Owners of earlier 4Runners should check the manual for their model year.

What headlight bulb does a Toyota 4Runner use?
For the 4Runner models these manuals cover, none you can buy and swap yourself. Toyota's 4Runner owner's manuals published in May 2026 (OM35C28U and the hybrid OM35C29U) list the headlights among the lights that need to be replaced by your Toyota dealer, and say the lights other than the front turn signal/parking lights (bulb type) consist of a number of LEDs. The one bulb with do-it-yourself steps is the front turn signal/parking light, bulb No. 7444NA, on vehicles that have the bulb type.
4Runner light bulb number and wattage
| Light | Bulb No. | Watts | Type |
|---|---|---|---|
| Front turn signal/parking lights (bulb type) | 7444NA | 28/8 | Wedge base bulb (amber) |
From the Light bulbs table in Toyota's 4Runner Owner's Manual (OM35C28U), page 625, and 4Runner hybrid Owner's Manual (OM35C29U), page 627, read November 16, 2026. Neither table lists a headlight bulb.
Lights your Toyota dealer replaces
Both manuals list these 4Runner lights as ones that need to be replaced by your Toyota dealer:
- Headlights
- Daytime running lights
- Front turn signal/parking lights (LED type)
- Front fog lights
- Side marker lights
- Side turn signal lights
- Tail lights
- Stop lights
- Back-up light
- Rear turn signal lights
- License plate lights
- High mounted stoplight
- Trailer hitch light
The hybrid manual also lists the light bar (if equipped). Both manuals explain that the lights other than the front turn signal/parking lights (bulb type) consist of a number of LEDs. If any of the LEDs burn out, they say to take the vehicle to your Toyota dealer to have the light replaced.
Replacing a 4Runner front turn signal/parking bulb
For the front turn signal/parking lights (bulb type), the manuals' steps are:
- Passenger's side only: remove the push clips and the air cleaner inlet.
- Turn the bulb base counterclockwise.
- Remove the light bulb.
- Install a new light bulb and turn the bulb base clockwise.
- Passenger's side only: install the air cleaner inlet and push clips.
The manuals say to check the wattage of the bulb to be replaced first, to confirm the bulb is properly engaged with the bulb base with no light leakage, and to contact your Toyota dealer if a replacement seems difficult to perform.
Before you change a 4Runner bulb
Toyota recommends genuine Toyota products designed for the vehicle when replacing light bulbs: because certain bulbs are connected to circuits designed to prevent overload, non-genuine parts or parts not designed for this vehicle may be unusable. The manuals' warnings include:
- Turn off the lights and do not replace the bulb right after turning them off. The bulbs become very hot and may cause burns.
- Do not touch the glass portion of the bulb with bare hands. If you must hold it, use a clean dry cloth. A scratched or dropped bulb may blow out or crack.
- Fully install light bulbs and any parts used to secure them, and make sure bulbs are fully seated and locked, to prevent heat damage, fire or water entering the light unit.
- Do not attempt to repair or disassemble light bulbs, connectors, electric circuits or component parts. Doing so may result in death or serious injury due to electric shock.
If the lights do not turn on even after a fuse has been replaced, the manuals say a bulb may need replacement.
4Runner headlight leveling dial
| Passengers | Payload | Single projection lamp | Dual projection lamp |
|---|---|---|---|
| Driver only | None | 0 | 0 |
| Full occupancy | None | 1 | 1 |
| Full occupancy | Maximum load | 3 | 2 |
| Driver only | Maximum load | 4 | 3 |
From the manual headlight leveling dial guide in Toyota's 4Runner Owner's Manual (OM35C28U), pages 237-238, read November 16, 2026. Maximum load means the weight capacity of the rear axle or the overall vehicle has been reached. The manual recommends keeping the headlights as close to the 0 position as possible so they do not interfere with other road users.
How the 4Runner headlights work
The headlight switch has an AUTO position: the headlights, daytime running lights and the other lights the switch controls turn on and off automatically. AUTO mode can be used when the engine switch (power switch on the hybrid) is in ON. The manual says the headlight control sensor may not function properly if an object is placed on it or anything that blocks it is affixed to the windshield. With the switch in AUTO, the headlights also turn on automatically several seconds after the windshield wipers are used in daytime.
Daytime running lights turn on automatically when the engine is started (the hybrid system is operating on the hybrid), the parking brake is released and the headlight switch is in a qualifying position. On vehicles with bulb-type front turn signal lights, they use the low beam headlights at reduced brightness; with LED-type front turn signal lights, they use the parking lights at higher brightness. In the U.S., they can be turned off with the switch, and the manual says they are not designed for use at night.
With the headlights on, push the lever forward for high beams. Pull the lever toward you and release it to flash the high beams once; the manual says you can do that with the headlights on or off. The Automatic High Beam uses a front camera on the upper windshield to switch between high and low beams. Among its conditions, it can turn the high beams on at about 21 mph or more and changes to low beams if speed drops below about 17 mph. The manual warns not to overly rely on it. If the headlights or tail lights are left on when the engine switch is turned off, a battery-saving function turns all the lights off after about 20 minutes.
If "Headlight System Malfunction Visit Your Dealer" appears on the multi-information display, the manual says the LED headlight system or the Automatic High Beam may be malfunctioning; have the vehicle inspected by your Toyota dealer immediately.
Peoria Toyota hours
| Department | Hours |
|---|---|
| Sales | Mon-Fri 9 a.m.-7 p.m.; Sat 9 a.m.-5 p.m.; Sun closed |
| Service | Mon-Fri 7 a.m.-5:30 p.m.; Sat 7 a.m.-12 p.m.; Sun closed |
From Peoria Toyota's website, November 16, 2026. Holiday hours can differ.
Toyota 4Runner headlight and bulb FAQ
What headlight bulb does a Toyota 4Runner use?
Toyota's 4Runner owner's manuals published in May 2026 (OM35C28U and the hybrid OM35C29U) do not list a replaceable headlight bulb. Both put the headlights on the list of lights that need to be replaced by your Toyota dealer, and both say the lights other than the front turn signal/parking lights (bulb type) consist of a number of LEDs. If you own an earlier 4Runner, check the owner's manual for your model year.
Can I replace a 4Runner headlight myself?
No, according to the manuals. The only light with do-it-yourself replacement steps is the front turn signal/parking light (bulb type). For other lights, the manuals say to contact your Toyota dealer.
What bulb is the 4Runner front turn signal/parking light?
Both manuals list bulb No. 7444NA, 28/8 W, an amber wedge base bulb, for the front turn signal/parking lights. Vehicles with LED type front turn signal/parking lights do not use this bulb; those are on the dealer-replaced list.
What happens if a 4Runner LED light burns out?
The manuals say that if any of the LEDs burn out, take your vehicle to your Toyota dealer to have the light replaced.
How do I adjust the 4Runner headlight aim for a load?
The 4Runner has a manual headlight leveling dial. The manual gives dial positions by loading condition, from 0 with only the driver and no payload up to 4 (single projection lamp) or 3 (dual projection lamp) with only the driver and a maximum load. It recommends keeping the headlights as close to the 0 position as possible so they do not interfere with other road users.
Is water inside a 4Runner headlight a problem?
The manuals say temporary condensation on the inside of the headlight lens does not indicate a malfunction. Contact your Toyota dealer if large drops of water have built up on the inside of the lens or water has built up inside the headlight.
Can Peoria Toyota replace a 4Runner headlight?
Yes. Our service team at 7401 N Allen Rd in Peoria can inspect and replace 4Runner headlights and other exterior lights. See the service hours above or schedule online.
4Runner light out?
Bring it to Peoria Toyota, 7401 N Allen Rd in Peoria. Our service team can inspect the light and replace an LED unit or bulb with genuine Toyota parts.
- Toyota 4Runner battery guide
- Toyota 4Runner oil type and capacity
- Toyota 4Runner tire pressure guide
- Toyota 4Runner maintenance schedule
- Toyota 4Runner dimensions
- Toyota 4Runner ground clearance
- Toyota 4Runner colors
- Toyota key fob battery replacement
- Toyota 4Runner at Peoria Toyota
- Toyota parts
- Service specials
Sources
The bulb number, wattage, the list of dealer-replaced lights, replacement steps, warnings, leveling dial positions and headlight operation are from Toyota's 4Runner (OM35C28U) and 4Runner hybrid (OM35C29U) owner's manuals, read November 16, 2026. Your own owner's manual is the final word for your vehicle. Address and hours are from Peoria Toyota's own website. Photo is illustrative.
- 4Runner Owner's Manual (OM35C28U): headlight switch, high beams, leveling dial and Automatic High Beam (pp. 235-239), fuses and light bulbs (pp. 562-565), Headlight System Malfunction message (p. 589), light bulb specifications (p. 625), Toyota, read November 16, 2026
- 4Runner hybrid Owner's Manual (OM35C29U): headlight switch (pp. 235-236), light bulbs (pp. 564-567), light bulb specifications (p. 627), Toyota, read November 16, 2026
- Address and sales and service hours, Peoria Toyota, November 16, 2026
